Shane on March 6th, 2011

Just picked these up last week. First to be restored is this Wysong and Miles Mortiser. Paid $275.00 for it, not a bottom feeders price, but a fair price for the condition that it’s in. The motor sounds great and everything works as it should. It should be a beauty when I am done with […]

Share on Facebook

Continue reading about My Next Two Restorations

Shane on December 28th, 2010

I finished the restoration on my Crescent Planer. It turned out great! Share on Facebook

Share on Facebook

Continue reading about 1912 18 inch Crescent Planer Restoration

Shane on September 27th, 2009

The drive wheel for the variable feed on the Crescent planer was in sad shape so I decided to replace it. It’s not an original but it’s been on there a long time.  It’s starting to crack and is to fat, which made it so I couldn’t set the feed rate slow enough. I pulled […]

Share on Facebook

Continue reading about Changing the Friction Drive Wheel on my Crescent Planer

Shane on September 26th, 2009

Video of the 18 inch Crescent Planer running. If you can’t see the video here try viewing it on youtube by Clicking Here Video I shot a while back of my Oliver 270 passing the change tests while cutting a board. If the video doesn’t work you can see it here Please leave a comment, […]

Share on Facebook

Continue reading about Videos

Shane on September 13th, 2009

This weekend I made a jig for sharpening the planer blades. The blades are 1/4 inch thick with a strip of HSS (I assume) welded to it for the cutting edge. The blades are made by Simonds Saw and Steel Co. (capture from 1926 Popular Science ad) Tungsweld When I first looked at these I […]

Share on Facebook

Continue reading about Sharpening Jig for 18 inch Planer Blades